| *A | w/ Double Locking System | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door belt moulding assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for both the RH and LH side.
The procedure described below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
68174A
5.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
89225
7.REMOVE MULTIPLEX NETWORK DOOR REAR ECU (w/ Double Locking System)
67646A
8.REMOVE REAR DOOR ARMREST SET BRACKET LH
68152C
10.REMOVE REAR DOOR GLASS RUN LH
68124B
12.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
75740
14.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH
|
Remove in this Direction |
|
Push in this Direction |
Put protective tape around the rear door belt moulding assembly LH.
Detach the claw and remove the rear door belt moulding assembly LH as shown in the illustration.