Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0455055 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  Recirculated/Fresh Air Modes Switch without User Input  


DESCRIPTION

If fresh/recirculation mode changes unintentionally and without permission, the following causes are possible.

Symptom Factor
·

Fresh/recirculation mode changes without permission

·

Fresh/recirculation mode light blinks


·

Customize setting

·

Change in fresh air temperature

·

Refrigerant pressure drop

·

Pressure sensor circuit malfunction

·

High FC stack outlet coolant temperature



PROCEDURE

1.CHECK CUSTOMIZE SETTING
a.

Use the following customize setting methods to confirm that the automatically fresh/recirculation mode is "ON". If the setting is on, select the setting to "OFF".

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>CUSTOMIZE PARAMETERS

OK:

Customize setting is "OFF".



Result:
Proceed to
OK
NG



OK

2.READ VALUE USING GTS (AMBIENT TEMP SENSOR)

NG

CHANGE CUSTOMIZE SETTING IS ON

2.READ VALUE USING GTS (AMBIENT TEMP SENSOR)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Ambient Temp Sensor Thermistor assembly Min.: -23.30°C (-9.94°F)
Max.: 65.95°C (150.71°F)
Actual ambient temperature displayed Thermistor assembly system malfunction
·

When open circuit: -23.30°C (-9.94°F)

·

When short circuit: 65.95°C (150.71°F)


Body Electrical > Air Conditioner > Data List
Tester Display
Ambient Temp Sensor
50003 121 2
OK:

The value of the display does not change frequently.



Result:
Proceed to
OK
NG



OK

3.READ VALUE USING GTS (COOLANT TEMPERATURE)

NG

3.READ VALUE USING GTS (COOLANT TEMPERATURE)
a.

Read the Data List according to the display on the GTS.

Powertrain > EV > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FC Stack Outlet Coolant Temperature (Filtered Value) FC stack outlet coolant temperature -40°C (-40°F) to 215.9 °C (421 °F) 50 to 85 °C (122 to 185 °F): After warming up -
Powertrain > EV > Data List
Tester Display
FC Stack Outlet Coolant Temperature (Filtered Value)
50003 397 998
OK:

The value of the display does not change frequently.



Result:
Proceed to
OK
NG



OK

4.CHECK REFRIGERANT PRESSURE

NG

4.CHECK REFRIGERANT PRESSURE
a.

Read the Data List according to the display on the GTS.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Regulator Pressure Sensor Air conditioner pressure sensor Min.: -456.68 kPaG
Max.: 3294.37 kPaG
Actual refrigerant pressure displayed Air conditioner pressure sensor system malfunction
Body Electrical > Air Conditioner > Data List
Tester Display
Regulator Pressure Sensor
50003 121 52


c.

Read the manifold gauge pressure when the following conditions are met.

i.

Prepare the vehicle according to the table below.

Item Condition
Door Fully closed (windows also fully closed)
A/C Switch On
Recirculation/fresh Control Switch Recirculation
Set Temperature MAX COLD
Blower Speed HI
Air Conditioning Air Inlet Temperature 25 to 35°C (77 to 95°F)



Standard Pressure:
Low pressure side:

150 to 250 kPa (1.5 to 2.5 kgf/cm2, 22 to 36 psi)

High pressure side:

1370 to 1570 kPa (14 to 16 kgf/cm2, 199 to 228 psi)


d.

Compare the values displayed in the Data List and on the manifold gauge.

OK:

The values displayed in the Data List and on the manifold gauge match.



Result:
Proceed to
OK
NG



OK

GO TO ON-VEHICLE INSPECTION (CHECK REFRIGERANT PRESSURE USING GAUGE)

NG