Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › from 2021.08
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448069 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B607240N02
0.313,0.156 2.469,1.417 2.156,1.26 0.313,1.417 2.469,2.677 2.156,1.26 1.708,0.76 2.073,0.76 true 4.74,2.167 5.208,2.167 true 6.552,0.177 6.906,0.177 false 6.573,0.563 6.854,0.563 false 5.146,1.042 5.75,1.042 true 3.021,3.479 3.792,3.479 true 1.792,2.073 2.156,2.073 true 4.146,0.5 4.458,0.698 0.313,0.198 10 false x 4 6.354,0.052 6.635,0.406 0.281,0.354 18 false 1 6.375,0.438 6.656,0.792 0.281,0.354 18 false 2 2.177,0.615 2.458,0.969 0.281,0.354 18 false 3 2.219,1.958 2.5,2.313 0.281,0.354 18 false 4 3.844,3.365 4.125,3.719 0.281,0.354 18 false 5 6.135,0.927 6.417,1.281 0.281,0.354 18 false 6 4.635,2.594 4.948,2.792 0.313,0.198 10 false x 2 4.188,2.49 4.5,2.688 0.313,0.198 10 false x 2 0.354,0.26 0.667,0.563 0.313,0.302 12 false *A 5.573,2.052 5.854,2.406 0.281,0.354 18 false 7 0.375,1.521 0.688,1.823 0.313,0.302 12 false *B

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 MULTI-DISPLAY ASSEMBLY WITH BRACKET - - - -
4 RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET - - - -
5 GLOVE COMPARTMENT DOOR ASSEMBLY 55550 - - -
6 NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 55403E (Click here) - -
7 INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY 73960A (Click here) - -

*A w/ Navigation System *B w/o Navigation System

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the instrument panel passenger without door airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 3.REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET (w/ Navigation System)

Hide 4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

Hide 55550 5.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55403E 6.REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

a.
B605582C01
2.448,0.76 2.76,1.063 0.313,0.302 18 true i 4.448,1.146 4.688,1.448 0.24,0.302 18 true iv 3.438,1.51 3.656,1.781 0.219,0.271 18 true ii 3.958,1.479 4.26,1.781 0.302,0.302 18 true iii 2.729,1.531 3.031,1.781 0.302,0.25 18 true iii 4.229,1.51 4.688,1.76 0.458,0.25 12 true (*A)
*A for Dual Type - -


i.

Detach the clamp.


ii.

for Single Type:

Disconnect the airbag connector.

HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



iii.

for Dual Type:

Disconnect the 2 airbag connectors.

HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



iv.

Remove the 2 bolts.



b.
B605584C02
0.542,0.104 0.792,0.448 0.25,0.344 18 true i 0.583,2.552 0.833,2.896 0.25,0.344 18 true ii
V113147

Remove in this Direction - -


i.

Remove the 4 screws.


ii.

Detach the clip and remove the No. 2 instrument panel safety pad sub-assembly as shown in the illustration.



Hide 73960A 7.REMOVE INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY

Z101186

CAUTION:
B528869

·

When storing the instrument panel passenger without door airbag assembly, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B593382N02
0.302,0.875 0.583,1.229 0.281,0.354 18 false i 3.74,0.177 4.021,0.531 0.281,0.354 18 false ii 3.729,2.25 4.01,2.604 0.281,0.354 18 false iii

i.

Remove the 2 screws.


ii.

Lean the instrument panel safety pad sub-assembly and detach the hook.


iii.

Detach the hook to remove the instrument panel passenger without door airbag assembly from the No. 2 instrument panel safety pad sub-assembly.