| *A | for LHD | *B | for RHD |
| *C | w/o Passenger Side Knee Airbag | *D | w/ Passenger Side Knee Airbag |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during glove box light assembly assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION (for LHD, w/ Passenger Side Knee Airbag)
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for LHD, w/ Passenger Side Knee Airbag)
|
|
58833B
4.REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
58834B
5.REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
55470
6.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
67913
7.REMOVE FRONT DOOR SCUFF PLATE RH
55607
8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55435A
10.REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD, w/o Passenger Side Knee Airbag)
73990
11.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD, w/ Passenger Side Knee Airbag)
55479D
12.REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL GARNISH
55550
13.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)
14.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)
|
Remove in this Direction | - | - |
81260
15.REMOVE GLOVE BOX LIGHT ASSEMBLY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |