Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Front Passenger Side) › from 2021.08
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0483295 KNEE AIRBAG ASSEMBLY(for Front Passenger Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Front Passenger Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B593283N01
6.417,0.375 6.75,0.375 false 2.76,0.594 3.469,0.594 false 1.563,2.729 1.979,2.729 false 6.458,0.729 6.74,0.729 false 3.198,1.885 3.198,2.135 false 5.646,1.313 6.073,1.313 false 4.26,2.552 4.802,2.552 false 3.125,2.198 3.406,2.563 0.281,0.365 18 false 4 3.771,0.438 4.052,0.792 0.281,0.354 18 false 7 6.385,1.146 6.667,1.5 0.281,0.354 18 false 5 2.125,2.615 2.406,2.969 0.281,0.354 18 false 6 2.073,1.333 2.385,1.531 0.313,0.198 10 false x 2 6.26,0.229 6.542,0.583 0.281,0.354 18 false 1 6.281,0.615 6.563,0.969 0.281,0.354 18 false 2 4.896,2.427 5.177,2.781 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 FRONT DOOR SCUFF PLATE RH 67913 - - -
4 NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55607 - - -
5 NO. 2 INSTRUMENT SIDE PANEL 55318F (Click here) - -
6 UPPER NO. 2 CONSOLE PANEL GARNISH 58834B - - -
7 LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 73990 (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the lower No. 2 instrument panel airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 67913 3.REMOVE FRONT DOOR SCUFF PLATE RH

Hide 55607 4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55318F 5.REMOVE NO. 2 INSTRUMENT SIDE PANEL

Z101186

Click here(Click here)

Hide 58834B 6.REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

Hide 73990 7.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Z101186

CAUTION:
B528852

·

When storing the lower No. 2 instrument panel airbag assembly, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:
·

When remove the lower No. 2 instrument panel airbag assembly, do not pull the airbag wire harness.

·

When disconnecting any airbag connector, take care not to damage the airbag wire harness.




a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B593285C01
1.125,1.885 1.406,2.24 0.281,0.354 18 true i 2.896,1.865 3.177,2.219 0.281,0.354 18 true i 0.51,0.115 0.792,0.469 0.281,0.354 18 true ii 5.208,1.5 5.49,1.854 0.281,0.354 18 true iii
V113147

Remove in this Direction - -


i.

Remove the 2 bolts.


ii.

Detach the clip and remove the lower No. 2 instrument panel airbag assembly the direction of the arrow shown in the illustration.


iii.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR