| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRE-CHECK | - | ( )
|
- | - |
| 2 | FC CONVERTER ASSEMBLY | G9A10 | - | - | - |
| ● | Non-reusable part | - | - |
1. PRE-CHECK
Since high voltage accumulates within the FC stack assembly with FC converter, never perform the work of disassembling the FC converter assembly itself or internal parts without first performing electrical charge discharge (forced electrical charge discharge or electrical charge self-discharge), because the high voltage circuit could cause electric shock.
Never perform work with the FC converter assembly installed in the vehicle.
Never perform work if the FC converter assembly is not standing alone.
Check "Pre-work" prior to working in order to perform work safely.
Pre-work
Electrical charge discharge (forced electrical charge discharge or electrical charge self-discharge) must have been performed.
Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL
The FC stack assembly with FC converter with front frame assembly must have been removed from the vehicle.
Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL
The FC converter assembly must be standing alone.
Click hereEngine / Hybrid System>FC CONTROL>CONVERTER ASSEMBLY>REMOVAL
G9A10
2.REMOVE FC CONVERTER ASSEMBLY
5.REMOVE FC COOLING WATER PUMP INVERTER ASSEMBLY AND FC HYDROGEN PUMP INVERTER ASSEMBLY