Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor) › from 2021.08
RM37H0E _58 Vehicle Interior _095303 THEFT DETERRENT / KEYLESS ENTRY _0448184 ELECTRICAL KEY OSCILLATOR(for Front Floor) A

THEFT DETERRENT / KEYLESS ENTRY  ELECTRICAL KEY OSCILLATOR(for Front Floor)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E471270N01
4.281,0.781 4.958,0.781 false 2.375,1.479 3.052,1.479 false 3.698,2.104 4.26,2.104 false 6.625,0.188 6.844,0.188 false 6.146,0.031 6.333,0.333 0.188,0.302 18 false 1 5.021,0.615 5.198,0.927 0.177,0.313 18 false 2 3.938,1.302 4.198,1.479 0.26,0.177 10 false x 2 2.146,1.354 2.344,1.667 0.198,0.313 18 false 3 4.333,1.948 4.531,2.26 0.198,0.313 18 false 4 6.313,0.083 6.667,0.302 0.354,0.219 12 false (*A)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 CONSOLE BOX ASSEMBLY 58810J - - -
3 NO. 1 CONSOLE BOX DUCT 58861B - - -
4 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY 899A0 - - -

*A w/ Passenger Side Knee Airbag - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the No. 1 indoor electrical key antenna assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function When Necessary Procedure are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION (w/ Passenger Side Knee Airbag)

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 58810J 2.REMOVE CONSOLE BOX ASSEMBLY

Hide 58861B 3.REMOVE NO. 1 CONSOLE BOX DUCT

Hide 899A0 4.REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

a.
E452615