When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, theservo motor and expansion valve standardposition is recognized. | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
73900
2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
3.REMOVE AIR DUCT SUB-ASSEMBLY
55844
4.REMOVE NO. 2 HEATER TO REGISTER DUCT
86572
5.REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER
|
|
|
Nut |
|
Connector |