Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Driver Side) › from 2021.08
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0483294 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B605577N01
6.354,0.25 6.823,0.25 false 6.302,0.656 6.771,0.656 false 0.813,3.688 1.563,3.688 false 4.656,3.083 5.125,3.083 false 5.188,0.698 5.656,0.698 false 1.208,1.969 1.677,1.969 false 3.542,0.635 4.01,0.635 false 3.698,1.635 4.167,1.635 false 6.01,1.906 5.646,1.906 false 2.49,1.073 2.49,0.771 2.49,0.771 2.313,0.771 false 4.958,4.198 5.281,4.198 false 6.052,0.104 6.333,0.458 0.281,0.354 18 false 1 6.063,0.51 6.344,0.865 0.281,0.354 18 false 2 5.354,3.458 5.667,3.656 0.313,0.198 10 false x 4 6.021,4.531 6.333,4.729 0.313,0.198 10 false x 3 2.167,0.677 2.479,0.875 0.313,0.198 10 false *1 1.729,3.542 2.01,3.896 0.281,0.354 18 false 3 4.792,4.052 5.073,4.406 0.281,0.354 18 false 4 1.979,1.844 2.26,2.198 0.281,0.354 18 false 5 4.135,0.479 4.417,0.833 0.281,0.354 18 false 6 5.375,2.927 5.792,3.281 0.417,0.354 18 false 10 4.24,1.51 4.521,1.865 0.281,0.354 18 false 7 5.49,1.771 5.771,2.125 0.281,0.354 18 false 8 5,0.552 5.281,0.906 0.281,0.354 18 false 9

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 FRONT DOOR SCUFF PLATE LH 67914B - - -
4 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55606 - - -
5 NO. 1 INSTRUMENT SIDE PANEL 55317E (Click here) - -
6 INSTRUMENT CLUSTER FINISH PANEL ORNAMENT 55471A - - -
7 LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 55045 - - -
8 UPPER NO. 1 CONSOLE PANEL GARNISH 58833B - - -
9 LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 55046A - - -
10 LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 73900 (Click here) - -

*1 HOOD LOCK CONTROL LEVER - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lower No. 1 instrument panel airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Memorize steering angle neutral point Panoramic View Monitor System (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

a.

Use the same procedure described for the RH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL


Hide 55606 4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55317E 5.REMOVE NO. 1 INSTRUMENT SIDE PANEL

Z101186

Click here(Click here)

Hide 55471A 6.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

Hide 55045 7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 58833B 8.REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

Hide 55046A 9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 73900 10.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Z101186

CAUTION:
B528852

·

When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B605578C01
3.052,0.24 3.208,0.51 0.156,0.271 18 true i 2.865,1.542 3.021,1.813 0.156,0.271 18 true i 1.083,1.5 1.24,1.771 0.156,0.271 18 true i 0.802,0.458 0.958,0.729 0.156,0.271 18 true i 1.427,3.396 1.667,3.677 0.24,0.281 18 true iii 2.594,3.51 2.833,3.792 0.24,0.281 18 true iii 2.542,2.417 2.823,2.698 0.281,0.281 18 true iv 4.417,2.104 4.677,2.385 0.26,0.281 18 true v 4.104,0.073 4.26,0.344 0.156,0.271 18 true ii
V113147

Remove in this Direction - -


i.

Remove the 4 bolts.


ii.

Detach the hook to remove the lower No. 1 instrument panel airbag assembly.


iii.

Detach the claw of the hood lock control lever, and then pull it out in the direction indicated by the arrow.


iv.

Detach the wire harness clamp.


v.

Disconnect the airbag connector and remove the lower No. 1 instrument panel airbag assembly.

HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR