Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use these procedures to troubleshoot the theft deterrent system.
  2. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the result is not as specified, recharge or replace the battery before proceeding.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
    1. Use Techstream, check for normal function of the multiplex communication system (Click here).
      Result: 
      Result
      Proceed to
      MPX DTC is not output
      A
      MPX DTC is output
      B



    B.
    Go to MULTIPLEX COMMUNICATION SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Data List/ Active Test (Click here)

    3. Terminals of ECU (Click here)

    4. Inspection

      1. Engine hood courtesy switch (Click here)

      2. Security horn (Click here)


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END