Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the smart key system.
  1. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
    1. Use the Techstream to check if the multiplex communication system (MPX) is functioning normally.
      Result 
      Result
      Proceed to
      MPX DTC is not output
      A
      MPX DTC is output
      B



    B.
    Go to MULTIPLEX COMMUNICATION SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).

      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. On-vehicle inspection (Click here)

    2. DATA LIST/ACTIVE TEST (Click here)

    3. Terminals of ECU (Click here)


    NEXT


    6.REPAIR OR REPLACE

      NEXT

      END