Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the Electronic Power Steering System (EPS).
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Record DTCs (Click here) and freeze frame data (Click here).


    NEXT


    4.PROBLEM SYMPTOM CONFIRMATION
      Result 
      Result
      Proceed to
      Symptom does not occur
      A
      Symptom occurs
      B


    B.
    Go to step 6
    A


    5.SYMPTOM SIMULATION

      NEXT


      6.CHECK CAN COMMUNICATION SYSTEM*
      1. Check for DTCs.
        Result 
        Result
        Proceed to
        CAN system DTC is not output.
        A
        CAN system DTC is output.
        B

        HINT:
        1. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first (Click here).
        2. When communication to the power steering ECU is not established through the Techstream, inspect terminals SIL of the DLC3 and power steering ECU and inspect the IG circuit of the power steering ECU.



      B.
      PROCEED TO CAN COMMUNICATION SYSTEM
      A


      7.CHECK DTC*
      1. Check for a DTCs.
        Result 
        Result
        Proceed to
        DTC is not output.
        A
        DTC is output.
        B



      B.
      Go to step 11
      A


      8.PROBLEM SYMPTOMS TABLE

        NEXT


        9.CIRCUIT INSPECTION

          NEXT


          10.IDENTIFICATION OF PROBLEM

            NEXT


            11.REPAIR OR REPLACE

              NEXT


              12.CONFIRMATION TEST

                NEXT

                END