Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential cause of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by the checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays to this system before inspecting the suspected areas below.


Result list of how to proceed with troubleshooting 
Symptom
Suspected Area
See page
Open in CAN Main Wire
CHECK CAN MAIN WIRE DISCONNECTION
Click here
Short in CAN Bus Line
CHECK CAN BUS LINE FOR SHORT CIRCUIT
Click here
Short to B+ CAN Bus Line
CHECK CAN BUS LINE FOR SHORT TO B+
Click here
Short to GND in CAN Bus Line
CHECK CAN BUS LINE FOR SHORT TO GND
Click here

Communication stop mode table 
Symptom
Suspected Area
See page
Hybrid Control is not displayed on Techstream via CAN VIM.
HYBRID VEHICLE CONTROL ECU COMMUNICATION STOP MODE
Click here
ABS / VSC / TRAC is not displayed on Techstream via CAN VIM.
SKID CONTROL ECU COMMUNICATION STOP MODE
Click here
Steering Angle Sensor is not displayed on Techstream via CAN VIM.
STEERING ANGLE SENSOR COMMUNICATION STOP MODE
Click here
Yaw Rate/Deceleration Sensor T is not displayed on Techstream via CAN VIM.
YAW RATE SENSOR COMMUNICATION STOP MODE
Click here
EPS is not displayed on Techstream via CAN VIM.
POWER STEERING ECU COMMUNICATION STOP MODE
Click here
Gateway is not displayed on Techstream via CAN VIM.
GATEWAY ECU COMMUNICATION STOP MODE
Click here
Engine is not displayed on Techstream via CAN VIM.
ECM ECU COMMUNICATION STOP MODE
Click here
HV Battery is not displayed on Techstream via CAN VIM.
BATTERY ECU COMMUNICATION STOP MODE
Click here