Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

SMART KEY SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the smart key system.
  2. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
    1. Use Techstream to check if Multiplex Communication System (MPX) is functioning normally.

      Result 
      Result
      Proceed to
      MPX DTC is not output
      A
      MPX DTC is output
      B



    B.
    GO TO MULTIPLEX COMMUNICATION SYSTEM
    A


    3.CHECK FOR DTC*
    1. Check for DTC and note any codes that are output.

    2. Delete the DTC.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Result 
      Result
      Proceed to
      The DTC does not reoccur
      A
      The DTC reoccurs
      B



    B.
    Go to step 6
    A


    4.PROBLEM SYMPTOMS TABLE

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. DATA LIST / ACTIVE TEST (Click here)

      1. Inspection with Techstream (DATA LIST)

      2. Inspection with Techstream (ACTIVE TEST)

    2. On-vehicle Inspection (Click here)

    3. Terminal of ECU (Click here)


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END