Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the power window control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF LARGE-SCALE BODY MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
    1. Using the Techstream, check if the Multiplex Communication System (MPX) is functioning normally.

      Result 
      Result
      Proceed to
      MPX DTC is not output
      A
      MPX DTC is output
      B



    B.
    Go to MULTIPLEX COMMUNICATION SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE

      Result 
      Result
      Proceed to
      If the fault is not listed in the problem symptoms table
      A
      If the fault is listed in the problem symptoms table
      B


    B.
    Go to step 7
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. DATA LIST / ACTIVE TEST (Click here)

    3. On-vehicle Inspection (Click here)

    4. Inspection (Click here)


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT


        8.RESET POWER WINDOW MOTOR
          If the power window switch AUTO light is blinking, reset the power window (Click here).

        NEXT

        END