The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the power switch is turned on (IG), power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually: When the power switch is turned on (IG), the MIL should be illuminated and should turn off after power switch on (READY). If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the intelligent tester.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Perform troubleshooting in accordance with the table below.
| Result | Proceed to |
|---|---|
| MIL remains on | A |
| MIL does not illuminate | B |
A
B
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check if any DTCs have been detected. Note down any DTCs.
| Result | Proceed to |
|---|---|
| DTC is not detected | A |
| Any DTCs are detected | B |
Check for detected DTCs output from other ECUs which relate to the MIL.
A
B
Disconnect the A40 ECM connector.
Turn the power switch on (IG).
Check that the MIL is not illuminated.
MIL is not illuminated.
| *a | Front view of wire harness connector
(to ECM) |
OK
NG
Disconnect the combination meter assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G1-24 (EFI) or A40-27 (W) - Body ground | Always | 10 kΩ or higher |
OK
NG
Check if the MIL is illuminated when the power switch is turned on (IG).
MIL should be illuminated.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Put the engine in inspection mode (maintenance mode) (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).
Start the engine.
| Result | Proceed to |
|---|---|
| Engine starts | A |
| Engine does not start* | B |
*: The tester cannot communicate with the ECM.
A
B
Disconnect the combination meter assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G1-24 (EFI) - A40-27 (W) | Always | Below 1 Ω |
OK
NG