1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58165F
2.REMOVE FRONT FLOOR COVER RH
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
89661
4.REMOVE ECM (for RHD)
Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
Remove the bolt and nut.
Remove the ECM.
Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.
5.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD)
55722C
6.REMOVE INNER COWL TOP TO COWL BRACE (for LHD)
55735B
7.REMOVE FRONT AIR SHUTTER SEAL (for LHD)
55815E
8.REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)
55701J
9.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
89661
10.REMOVE ECM (for LHD)
Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
Remove the bolt and nut.
Remove the ECM.
Remove the nut.
Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.