89892A
1.INSTALL BATTERY SMART UNIT
Wear insulated gloves.
w/o Wiring Harness Protector:
Install the battery smart unit to the HV battery with the bolt.
| *a | Red Label |
Check color of the label.
Connect the battery smart unit connector.
The connector should be connected securely.
w/ Wiring Harness Protector:
Install the battery smart unit to the HV battery with the bolt.
| *a | Red Label |
Check color of the label.
Install the wiring harness protector to the battery smart unit connector.
Connect the battery smart unit connector.
The connector should be connected securely.
Engage the 2 claws to install the wiring harness protector cover to the battery smart unit connector.
G920C
2.INSTALL NO. 2 HYBRID VEHICLE BATTERY CARRIER BRACKET SUB-ASSEMBLY
Wear insulated gloves.
Install the No. 2 hybrid vehicle battery carrier bracket sub-assembly with the bolt and 2 nuts.
Engage the 3 clamps.
Connect the battery smart unit connector.
The connector should be connected securely.
G920Q
3.INSTALL NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Wear insulated gloves.
Install the No. 1 hybrid battery shield sub-assembly with the 2 bolts and 2 nuts.
Install the electric vehicle battery plug with the bolt as shown in the illustration.
G92T9
4.INSTALL HYBRID BATTERY SERVICE PLUG COVER
Wear insulated gloves.
Install the hybrid battery service plug cover with the 2 nuts.
5.CONNECT WIRE HARNESS
Engage the clamp.
Connect the 2 connectors.
G92F1
6.INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT
Install the No. 1 hybrid battery exhaust duct with the clip.
71033
7.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
Temporarily install the rear seat cushion leg sub-assembly with the 4 bolts.
Tighten the bolt (A).
Tighten the bolt (B).
Tighten the 2 bolts (C).
8.INSTALL REAR SEAT CUSHION ASSEMBLY
G3834
9.INSTALL SERVICE PLUG GRIP