Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR › 2011.12–2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277930 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide G9200 1.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide G9040 3.REMOVE INVERTER WATER PUMP ASSEMBLY

a.
A266739

Disconnect the 2 water hoses.

NOTICE:

Put pieces of cloth into the pipes and in the disconnected hoses to prevent foreign matter from entering the inverter water pump and cooling system.



b.
A266741

Disconnect the connector.

NOTICE:

Apply insulating tape to the connectors of the wire harness and inverter water pump assembly with motor to prevent the entry of coolant.



c.

Remove the 3 bolts and the inverter water pump assembly.


Hide G9031A 4.REMOVE HV WATER PUMP BRACKET SUB-ASSEMBLY

a.
A266742

Disconnect the clamp.


b.

Remove the 2 bolts and the HV water pump bracket sub-assembly.