Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY BLOWER › 2014.12–2015.11
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277937 BATTERY BLOWER A

HYBRID / BATTERY CONTROL  BATTERY BLOWER  INSTALLATION  


PROCEDURE

Hide G9230 1.INSTALL BATTERY COOLING BLOWER ASSEMBLY

NOTICE:
·

Be sure not to touch the fan part of the battery cooling blower assembly.

·

Do not lift the battery cooling blower assembly using the wire harness.



a.

Install the battery cooling blower assembly with the nut and 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Connect the battery cooling blower assembly connector and engage the clamp.


Hide 2.INSTALL REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)

Hide 3.INSTALL REAR SEAT CUSHION ASSEMBLY (for Bench Type Seatback)

Hide 58167H 4.INSTALL FRONT CENTER FLOOR COVER (for Separate Type Seatback)

Hide 58167H 5.INSTALL FRONT CENTER FLOOR COVER (for Bench Type Seatback)

Hide 58166B 6.INSTALL FRONT FLOOR COVER LH (for Separate Type Seatback)

Hide 58166B 7.INSTALL FRONT FLOOR COVER LH (for Bench Type Seatback)

Hide 58165F 8.INSTALL FRONT FLOOR COVER RH (for Separate Type Seatback)

Hide 58165F 9.INSTALL FRONT FLOOR COVER RH (for Bench Type Seatback)

Hide 10. CLEAR DTC

HINT:

If the message "COOLING PERFORMANCE OF THE HYBRID BATTERY IS LOW VISIT YOUR DEALER" is displayed on the multi-information display, clean or replace the battery cooling blower assembly, and clear the DTCs to reset the learning values even if no DTCs are output (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DTC CHECK / CLEAR).