G9230
1.INSTALL BATTERY COOLING BLOWER ASSEMBLY
Be sure not to touch the fan part of the battery cooling blower assembly.
Do not lift the battery cooling blower assembly using the wire harness.
Install the battery cooling blower assembly with the nut and 2 bolts.
Connect the battery cooling blower assembly connector and engage the clamp.
2.INSTALL REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)
3.INSTALL REAR SEAT CUSHION ASSEMBLY (for Bench Type Seatback)
58167H
4.INSTALL FRONT CENTER FLOOR COVER (for Separate Type Seatback)
58167H
5.INSTALL FRONT CENTER FLOOR COVER (for Bench Type Seatback)
58166B
6.INSTALL FRONT FLOOR COVER LH (for Separate Type Seatback)
58166B
7.INSTALL FRONT FLOOR COVER LH (for Bench Type Seatback)
58165F
8.INSTALL FRONT FLOOR COVER RH (for Separate Type Seatback)
58165F
9.INSTALL FRONT FLOOR COVER RH (for Bench Type Seatback)
10. CLEAR DTC
If the message "MAINTENANCE REQUIRED FOR HYBRID BATTERY COOLING PARTS AT YOUR DEALER" is displayed on the multi-information display, clean or replace the battery cooling blower assembly, and clear the DTCs to reset the learning values even if no DTCs are output (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DTC CHECK / CLEAR).