Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › EGR COOLER
RM2170E _51 Engine / Hybrid System _057007 1NZ-FXE EMISSION CONTROL _0277960 EGR COOLER A

1NZ-FXE EMISSION CONTROL  EGR COOLER  INSTALLATION  


PROCEDURE

Hide 25680 1.INSTALL EGR COOLER ASSEMBLY

a.

Using an E8 "TORX" socket wrench, install the 2 stud bolts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


b.

Install a new gasket and the EGR valve assembly with the 2 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


c.

Connect the No. 1 water by-pass hose.


d.

Temporarily install a new gasket and the EGR valve with cooler assembly with the 2 bolts and 2 nuts.


e.

Install the EGR valve bracket with the 2 bolts and nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


f.

Install the EGR valve with cooler assembly with the 2 bolts and 2 nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

Make sure that all installation surfaces of the EGR valve with cooler assembly are in even contact when tightening the bolts and nuts.



g.
A275468E03
0.781,1.604 0.958,1.76 0.177,0.156 10 false *a 2.052,0.583 2.229,0.74 0.177,0.156 10 false *c 1.906,1.396 2.083,1.552 0.177,0.156 10 false *c 2.438,0.302 2.615,0.458 0.177,0.156 10 false *b 1.635,0.906 1.813,1.063 0.177,0.156 10 false *d

Connect the No. 4 water by-pass hose and No. 5 water by-pass hose.

Text in Illustration
*a 2 to 7 mm (0.079 to 0.276 in.)
*b Up
*c 90°
*d Engine Rear


h.

Install the wire harness clamp bracket with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


i.
A267673

Connect the 2 connectors and wire harness clamp.


Hide 55701J 5.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 6.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 55815E 7.INSTALL FRONT NO. 1 VENTILATOR SEAL (for LHD)

Hide 55815E 8.INSTALL FRONT NO. 1 VENTILATOR SEAL (for RHD)

Hide 55735B 9.INSTALL FRONT AIR SHUTTER SEAL (for LHD)

Hide 55735B 10.INSTALL FRONT AIR SHUTTER SEAL (for RHD)

Hide 55722C 11.INSTALL INNER COWL TOP TO COWL BRACE (for LHD)

Hide 55722C 12.INSTALL INNER COWL TOP TO COWL BRACE (for RHD)

Hide 13.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY