Home › Drivetrain › P510 (HYBRID TRANSMISSION / TRANSAXLE) › MOTOR CABLE
RM2170E _52 Drivetrain _057013 P510 HYBRID TRANSMISSION / TRANSAXLE _0277989 MOTOR CABLE A

P510 HYBRID TRANSMISSION / TRANSAXLE  MOTOR CABLE  INSTALLATION  


PROCEDURE

Hide G1148 1.INSTALL MOTOR CABLE

CAUTION:

Wear insulated gloves.


a.

Install the motor cable (for MG 1).

i.

Install the motor cable to the hybrid vehicle transaxle assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Keep the sealing surface of the generator cable and the connector terminal joint free of foreign matter.



ii.

Engage the 2 claws to install a new terminal cap to the hybrid vehicle transaxle assembly.

NOTICE:
·

Keep foreign matter, water, etc. away from the terminal cap and its installation section.

·

Do not pinch the O-ring.

·

Check that the terminal cap is securely installed.




iii.
C251935

Place the connector shell in position and install it with the 2 bolts.

Torque:
19 N*m (196 kgf*cm, 14 ft.*lbf)



b.

Install the motor cable (for MG 2).

i.

Install the motor cable to the hybrid vehicle transaxle assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Keep the sealing surface of the generator cable and the connector terminal joint free of foreign matter.



ii.

Engage the 2 claws to install a new terminal cap to the hybrid vehicle transaxle assembly.

NOTICE:
·

Keep foreign matter, water, etc. away from the terminal cap and its installation section.

·

Do not pinch the O-ring.

·

Check that the terminal cap is securely installed.




iii.
C251936

Place the connector shell in position and install it with the 2 bolts.

Torque:
19 N*m (196 kgf*cm, 14 ft.*lbf)



c.

Connect the 4 clamps and install the motor cable to the hybrid vehicle transaxle assembly.


Hide 2.CONNECT WIRE HARNESS

a.

Connect the clamp and install the wire harness to the hybrid vehicle transaxle assembly with the 2 bolts.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


b.

Connect the 3 clamps and install the No. 2 engine wire to the hybrid vehicle transaxle assembly.


Hide 33820B 3.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Connect the transmission control cable assembly to the transmission control cable clamp and transmission control cable support.


Hide G9110 4.INSTALL INVERTER BRACKET ASSEMBLY

Hide G9200 5.INSTALL INVERTER WITH CONVERTER ASSEMBLY