G9200
1.REMOVE INVERTER WITH CONVERTER ASSEMBLY
G9110
2.REMOVE INVERTER BRACKET ASSEMBLY
33820B
3.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Disconnect the transmission control cable assembly from the transmission control cable clamp and transmission control cable support.
| *1 | Transmission Control Cable Clamp |
| *2 | Transmission Control Cable Support |
4.DISCONNECT WIRE HARNESS
Disconnect the 3 clamps and No. 2 engine wire.
Remove the 2 bolts, clamp and wire harness from the hybrid vehicle transaxle assembly.
G1148
5.REMOVE MOTOR CABLE
Wear insulated gloves.
Disconnect the 4 clamps and motor cable from the hybrid vehicle transaxle assembly.
Remove the motor cable (for MG 2).
Remove the 2 bolts and slide the connector shell back.
Disengage the 2 claws to remove the terminal cap from the hybrid vehicle transaxle assembly.
Disconnect the 3 bolts and motor cable from the hybrid vehicle transaxle assembly.
Remove the motor cable (for MG 1).
Remove the 2 bolts and slide the connector shell back.
Disengage the 2 claws to remove the terminal cap from the hybrid vehicle transaxle assembly.
Remove the 3 bolts and motor cable from the hybrid vehicle transaxle assembly.