Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › 2014.12–2015.11
RM2170E _54 Brake _057021 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0278020 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C1300  Skid Control ECU Malfunction  


DESCRIPTION

The skid control ECU stores this DTC if malfunctions are found in the circuit inside the ECU by self diagnosis.

DTC No. INF Code DTC Detection Condition Trouble Area
C1300 - Skid control ECU internal malfunction. Skid control ECU (Brake booster with master cylinder assembly)

PROCEDURE

1.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
a.

Replace the skid control ECU (brake booster with master cylinder assembly) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER(for LHD)>REMOVAL for LHD or Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER(for RHD)>REMOVAL for RHD).


b.

Perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).


c.

Perform zero point calibration of the yaw rate and acceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>CALIBRATION).




NEXT

END