Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM2170E _54 Brake _057021 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0278020 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C1451/72  Motor Drive Permission Malfunction  


DESCRIPTION

If air bleeding has not been performed, the skid control ECU stores DTC C1451/72 to prevent the entry of air due to pump motor operation.

DTC C1451/72 is stored when Invalid Mode is selected, the system will not return to normal until the air bleeding procedure is performed.

DTC No. INF Code DTC Detection Condition Trouble Area
C1451/72 - Air bleeding has not been performed.
·

Brake fluid leaks

·

Air bleeding not performed



PROCEDURE

1.CHECK BRAKE FLUID LEVEL
a.

Check that the brake fluid level is sufficient.

OK:

Brake fluid level is sufficient.


HINT:
·

If the fluid level drops, check for fluid leaks, and repair as necessary.

·

If no fluid leaks exist, add and adjust fluid (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>ON-VEHICLE INSPECTION).





OK

2.PERFORM AIR BLEEDING

NG

CHECK AND REPAIR BRAKE FLUID LEAKS OR ADD FLUID

2.PERFORM AIR BLEEDING
a.

Bleed the air from the brake system (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING).

HINT:

If air bleeding has been performed, this DTC will be cleared.




NEXT

3.RECONFIRM DTC
3.RECONFIRM DTC
a.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1451/72 is output. A
DTC C1451/72 is not output. B




A

4.CLEAR DTC

B

END