Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace the front axle hub bearing.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
53876A
3.REMOVE FRONT FENDER LINER
Use the same procedure for the LH side and RH side (See page Vehicle Exterior>WIPER / WASHER>WASHER MOTOR(for Front Side)>REMOVAL).
89543
4.REMOVE FRONT SPEED SENSOR
Disengage the clamp from the body.
| *1 | No. 1 Clamp | *2 | No. 2 Clamp |
| *3 | No. 3 Clamp | - | - |
Disconnect the front speed sensor connector.
Remove the No. 3 clamp from the body.
Disengage the 2 clamps from the body.
Remove the bolt and separate the No. 2 clamp from the body.
Remove the bolt and separate the No. 1 clamp from the shock absorber.
Remove the bolt and the front speed sensor from the steering knuckle.
Keep the front speed sensor tip and installation portion free of foreign matter.
Remove the front speed sensor without turning it from its original installation angle.