Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM2170E _54 Brake _057021 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0278025 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 84307 1.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

a.

Install the spiral cable with sensor sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION).

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

·

Do not remove the steering angle sensor from the spiral cable.




Hide 45286B 2.INSTALL UPPER STEERING COLUMN COVER

Hide 45287 3.INSTALL LOWER STEERING COLUMN COVER

Hide 4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 84307 5.ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 6.INSTALL STEERING WHEEL ASSEMBLY