1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
55404D
3.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Use the same procedure for LHD and RHD (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
89510D
4.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY
84340
5.REMOVE STOP LIGHT SWITCH ASSEMBLY
84345
6.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
47101A
7.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring from the brake pedal support assembly.
47264A
8.REMOVE PUSH ROD PIN
Remove the clip and push rod pin.
Separate the push rod clevis from the brake pedal support assembly.
9.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.
Disengage the clamp and separate the wire harness from the brake pedal support assembly.
Disengage the wire harness clamp to separate it from the stud bolt of the brake booster with master cylinder assembly.
Remove the 4 nuts and brake pedal support assembly.