Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(for LHD) › from 2014.12
RM2170E _54 Brake _057022 BRAKE SYSTEM (OTHER) _0278033 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 55404D 4.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 84340 6.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 7.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47101A 8.REMOVE BRAKE PEDAL RETURN SPRING

a.
C249998

Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.


Hide 45259A 9.REMOVE COLUMN HOLE COVER SILENCER SHEET

Hide 45209 10.SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY

Hide 45260 11.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY

Hide 47264A 12.REMOVE PUSH ROD PIN

a.
C250000

Remove the clip and push rod pin to separate the brake pedal support assembly from the push rod clevis.


Hide 13.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C250002

Disengage the wire harness clamp from the brake pedal support assembly.


b.

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C250001

Disengage the wire harness clamp from the brake pedal support assembly.


d.
C250003

Remove the 4 nuts and brake pedal support assembly.