Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE › 2011.12–2014.12
RM2170E _54 Brake _057023 BRAKE (FRONT) _0278037 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.

·

If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 47313J 1.INSTALL FRONT FLEXIBLE HOSE

a.
C252582E03
1.896,1.188 1.99,1.104 false 2.635,0.302 2.729,0.396 2.729,0.396 2.844,0.396 false 2.49,0.146 2.625,0.146 false 2.448,0.604 2.573,0.604 false 2.646,0.052 2.802,0.198 0.156,0.146 10 false *1 2.865,0.313 3.021,0.458 0.156,0.146 10 false *2 1.969,0.99 2.135,1.135 0.167,0.146 10 true *3 2.583,0.521 2.75,0.677 0.167,0.156 10 false *a

Install a new clip to the front flexible hose.

Text in Illustration
*1 Brake Line
*2 Clip
*3 Bolt
*a Identification Mark

NOTICE:
·

Install the clip as far as it will go.

·

When installing the front flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.




b.

Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.

·

Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Install the front flexible hose and front speed sensor bracket to the absorber bracket with the bolt.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)

NOTICE:

Install the first front speed sensor bracket and then the front flexible hose.



d.
C249580E02
1.375,0.969 2.531,0.969 true 2.552,0.875 2.708,1.021 0.156,0.146 10 false *a

Connect the front flexible hose to the front disc brake cylinder assembly with a new union bolt and a new gasket.

Text in Illustration
*a Lock Hole

Torque:
30 N*m (310 kgf*cm, 22 ft.*lbf)

NOTICE:

Install the flexible hose lock securely into the lock hole in the front disc brake cylinder.



Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 4.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)