This DTC will be stored if the power steering ECU assembly determines that the assist map is not written in the ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1581/81 | Assist map not written in power steering ECU assembly | ·
CAN communication system ·
Hybrid control system ·
Power steering ECU assembly |
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1581/81 is output | A |
| DTC C1581/81 is not output | B |
DTC C1581/81 is cleared after the assist map is written.
A
B
Check for DTCs (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Check if any of the parts listed below have been replaced with an incorrect part in the past.
| Related Part | Power management control ECU |
When removing a related part to check it, be sure to follow the appropriate procedures and precautions.
Refer to the following procedures to remove the power management control ECU (See page Power Source / Network>POWER DISTRIBUTION>POWER MANAGEMENT CONTROL ECU>REMOVAL).
DTC C1581/81 is stored when a part with an incorrect part number is installed for the related parts listed above.
When DTC C1581/81 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.
| Result | Proceed to |
|---|---|
| All installed related parts have correct part number | A |
| Part with incorrect part number is installed | B |
A
B