Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2170E _55 Steering _057026 POWER ASSIST SYSTEMS _0278045 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1515/15  Torque Sensor Zero Point Adjustment is not Initialized  


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that torque sensor zero point calibration has not been performed.

DTC No. DTC Detection Condition Trouble Area
C1515/15 This DTC is stored when torque sensor zero point calibration has not been performed. There is no malfunction if this DTC is not output again after performing zero point calibration.

CAUTION / NOTICE / HINT

NOTICE:
·

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).

·

If the electric power steering column sub-assembly has been replaced with a new one, perform torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



PROCEDURE

1.CHECK FOR DTC
a.

Calibrate the torque sensor zero point (step 1) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


b.

Check for DTCs (step 2) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

HINT:

If DTCs are output, perform steps 1 and 2 two more times.


Result:
Result Proceed to
DTCs are still output after performing steering zero point calibration 3 times. A
Normal system code is output. B




A

2.REPLACE POWER STEERING ECU ASSEMBLY

B

END

2.REPLACE POWER STEERING ECU ASSEMBLY
a.

Replace the power steering ECU assembly (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU>REMOVAL).



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Calibrate the torque sensor zero point (step 1) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


b.

Check for DTCs (step 2) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

HINT:

If DTCs are output, perform steps 1 and 2 two more times.


Result
Result Proceed to
DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. A
Normal system code is output. B



A

REPLACE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY

B

END