This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that torque sensor zero point calibration has not completed.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1516/16 | Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. | There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration value, and performing zero point calibration. |
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
If the electric power steering column sub-assembly has been replaced with a new one, perform torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Clear the DTCs (step 1) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
Calibrate the torque sensor zero point (step 2) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Check for DTCs (step 3) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
If DTCs are output, perform steps 1 to 3 two more times.
| Result | Proceed to |
|---|---|
| DTCs are still output after performing steering zero point calibration 3 times. | A |
| Normal system code is output. | B |
A
B
Replace the power steering ECU assembly (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU>REMOVAL).
NEXT
Calibrate the torque sensor zero point (step 1) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Check for DTCs (step 2) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
If DTCs are output, perform steps 1 and 2 two more times.
| Result | Proceed to |
|---|---|
| DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. | A |
| Normal system code is output. | B |
A
B