Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.11
RM2170E _55 Steering _057026 POWER ASSIST SYSTEMS _0278045 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1582/82  Assist Map Number Mismatch  


DESCRIPTION

When an incorrect hybrid vehicle control ECU is installed after the assist map has been written to the power steering ECU assembly, then DTC C1582/82 is stored because the data does not match the vehicle specifications.

DTC No. DTC Detection Condition Trouble Area
C1582/82 Assist map number mismatch
·

CAN communication system

·

Incorrect hybrid vehicle control ECU

·

Power steering ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check for DTCs (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.CHECK RELATED PART (HYBRID VEHICLE CONTROL ECU)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITHTROUBLESHOOTING)

2.CHECK RELATED PART (HYBRID VEHICLE CONTROL ECU)
a.

Check if any of the parts listed below have been replaced with an incorrect part in the past.

Related Part Hybrid vehicle control ECU

NOTICE:

When removing a related part to check it, be sure to follow the appropriate procedures and precautions.

Refer to the following procedures to remove the hybrid vehicle control ECU (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID VEHICLE CONTROL ECU>REMOVAL).



HINT:
·

DTC C1582/82 is stored when a part with an incorrect part number is installed for the related parts listed above.

·

When DTC C1582/82 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.




Result
Result Proceed to
All installed related parts have correct part number A
Part with incorrect part number is installed B


A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER