Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › 2011.12–2017.06
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278055 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


PROCEDURE

Hide 1.REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

Hide 2.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

Hide 55840C 3.REMOVE NO. 6 HEATER TO REGISTER DUCT ASSEMBLY

Hide 86101 4.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.

for LHD:

i.

Disconnect each connector.


ii.

Remove the 2 bolts.

E244935


iii.

Disengage the 5 clamps and remove the antenna cord sub-assembly.



b.

for RHD:

i.

Disconnect each connector.


ii.

Remove the 2 bolts.

E247777


iii.

Disengage the 5 clamps and remove the antenna cord sub-assembly.



Hide 5.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86101J 6.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.

Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

HINT:

Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.



b.

Remove the No. 2 antenna cord sub-assembly from the roof headlining.

E237102E02
3.021,2.417 3.177,2.563 0.156,0.146 10 false *a 0.51,4.563 0.667,4.708 0.156,0.146 10 false *1

Text in Illustration
*1 Tape - -
*a Front - -