The illuminated entry system controls the power switch illumination.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start / Active Test.
Check that the illumination operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Power switch light | OFF/ON | When performing this Active Test, make sure the following condition is met:
The power switch illumination is off (15 seconds or more have elapsed since it turned from on to off) and the power switch is on (ACC) or on (IG), or the hybrid control system is running. |
Power switch illumination comes on.
OK
NG
Remove the power switch (See page Engine / Hybrid System>1NZ-FXE STARTING>POWER SWITCH>REMOVAL).
Inspect the power switch (See page Engine / Hybrid System>1NZ-FXE STARTING>POWER SWITCH>INSPECTION).
Power switch illumination comes on.
OK
NG
Disconnect the G79 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G48-9 (SWIL) - G79-16 (SWIL) | Always | Below 1 Ω |
| G48-6 (AGND) - G79-24 (AGND) | Always | Below 1 Ω |
| G48-9 (SWIL) - Body ground | Always | 10 kΩ or higher |
| G48-6 (AGND) - Body ground | Always | 10 kΩ or higher |
OK
NG