Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › 2011.12–2015.11
RM2170E _58 Vehicle Interior _057037 METER / GAUGE / DISPLAY _0278097 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  INSTALLATION  


PROCEDURE

Hide 83100 1.INSTALL COMBINATION METER ASSEMBLY

a.

Engage the clamp.


b.

Connect the 2 connectors.


c.
E244447

Engage the 3 clips.


d.

Install the combination meter assembly with the 2 screws.


Hide 55404D 2.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55670A 3.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55474B 4.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55660 5.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55650 6.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)

Hide 55405B 7.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

HINT:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).