Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278103 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 62211 2.REMOVE FRONT PILLAR GARNISH RH

Hide 82142A 3.DISCONNECT NO. 2 INSTRUMENT PANEL WIRE

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B300245E02
0.698,2.49 0.698,3 0.698,3 1.906,3 true 1.719,2.479 1.719,3 true 1.938,2.917 2.094,3.063 0.156,0.146 10 false *a

Slide the slider to release the lock, and then disconnect the connector.

Text in Illustration
*a Slider

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



Hide 5.REMOVE NO. 2 HEATER TO REGISTER DUCT ASSEMBLY

Hide 73960A 6.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.
B300247

Remove the 2 screws.


b.

Disengage the clamp from the upper instrument panel assembly.


c.
B300248

Lean the upper instrument panel assembly and disengage the 3 hooks.


d.
B300249

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the upper instrument panel assembly.


Hide 82142A 7.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B300250E01
0.99,0.473 1.152,0.648 0.161,0.175 10 *1 0.555,2.543 0.737,2.718 0.182,0.174 10 *3 1.002,2.74 0.891,2.629 0.891,2.629 0.744,2.629 false 0.365,1.054 0.526,1.229 0.161,0.175 10 *2 0.576,1.145 1.511,1.145 false 1.785,1.121 1.785,0.555 1.785,0.555 1.182,0.555 false

Separate the No. 2 instrument panel wire from the instrument panel passenger airbag assembly clamp.

Text in Illustration
*1 Protective Tape
*2 Airbag Connector
*3 Airbag Connector Lock


b.

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.


c.

Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.