Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR › 2014.12–2015.11
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278109 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 71940A 2.REMOVE REAR SEAT HEADREST ASSEMBLY

Hide 71960B 3.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY (for LH Side)

Hide 58165F 4.REMOVE FRONT FLOOR COVER RH

Hide 58166B 5.REMOVE FRONT FLOOR COVER LH

Hide 58167H 6.REMOVE FRONT CENTER FLOOR COVER

Hide 7.REMOVE REAR SEAT CUSHION ASSEMBLY

Hide 8.REMOVE REAR SEATBACK ASSEMBLY

Hide 9.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 62332A 11.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

HINT:

Disconnect the rear door opening trim weatherstrip to the extent that allows the removal of the deck trim side panel assembly.


Hide 64995 14.REMOVE DECK FLOOR BOX RH

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 64330D 15.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 73370 17.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

Hide 81330 18.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)

Hide 64740C 19.REMOVE DECK TRIM SIDE PANEL ASSEMBLY

Hide 89860C 20.REMOVE SIDE NO. 2 AIRBAG SENSOR ASSEMBLY

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Disconnect the connector from the side No. 2 airbag sensor assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

H103067E01
4.094,0.594 4.698,0.594 false 4.354,0.906 4.958,0.906 true 3.885,1.281 3.885,1.667 true 0.365,1.979 0.833,2.427 true 4.76,0.51 5.219,0.708 0.458,0.198 10 false (A) 5.031,0.854 5.49,1.052 0.458,0.198 10 false *1 3.833,1.698 4.292,1.896 0.458,0.198 10 false *2 0.188,1.802 0.646,2 0.458,0.198 10 false *a

Text in Illustration
*1 White Housing Lock *2 Yellow CPA
*a Connector Lock is Released - -


ii.

Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting the connector.




d.
B300267

Remove the bolt and side No. 2 airbag sensor assembly from the vehicle body.

NOTICE:

Loosen the bolt while holding the side No. 2 airbag sensor assembly because the side No. 2 airbag sensor assembly pin (stopper) is easily damaged.



e.

After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

B296255E06
4.763,1.829 4.955,2.012 0.192,0.183 10 *b 1.4,1.829 1.592,2.012 0.192,0.183 10 *b 4.763,0.568 4.955,0.751 0.192,0.183 10 *a 1.4,0.568 1.592,0.751 0.192,0.183 10 *a

Text in Illustration
*a Incorrect *b Correct