71511S
1.INSTALL OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
Temporarily install the occupant detection sensor (separate type front seat cushion pad).
Using hog ring pliers, install 18 new hog rings.
| *1 | New Hog Ring |
| *2 | Hog Ring Pliers |
Be careful not to damage the separate type front seat cushion cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
Using hog ring pliers, install the occupant detection sensor (separate type front seat cushion pad) to the separate type front seat cushion cover with 2 new hog rings.
| *1 | New Hog Ring |
| *2 | Hog Ring Pliers |
Be careful not to damage the separate type front seat cushion cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Use the same procedure as for the driver seat.
w/ Removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY)
w/ Non-removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(w/ Non-removable Headrest)>REASSEMBLY)
73910A
3.CONNECT FRONT SEAT AIRBAG ASSEMBLY
Use the same procedure as for the driver seat.
w/ Removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY)
w/ Non-removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(w/ Non-removable Headrest)>REASSEMBLY)
71073S
4.CONNECT SEPARATE TYPE FRONT SEAT BACK COVER
Use the same procedure as for the driver seat.
w/ Removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY)
w/ Non-removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(w/ Non-removable Headrest)>REASSEMBLY)
71811D
5.INSTALL FRONT SEAT CUSHION SHIELD
Use the same procedure as for the driver seat.
w/ Removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY)
w/ Non-removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(w/ Non-removable Headrest)>REASSEMBLY)
72525A
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE
Use the same procedure as for the driver seat.
w/ Removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY)
w/ Non-removable Headrest: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(w/ Non-removable Headrest)>REASSEMBLY)
73230
7.INSTALL FRONT SEAT INNER BELT ASSEMBLY