1.INSTALL PIPING CLAMP
Remove the vinyl tape from the open ends of the suction pipe sub-assembly and suction hose sub-assembly.
Install a new piping clamp onto the suction hose sub-assembly.
| *1 | Suction Hose Sub-assembly |
| *2 | Piping Clamp |
| *a | Groove |
Securely engage the inside step of the piping clamp in the suction hose sub-assembly groove.
Thoroughly coat 2 new O-rings and the contact surface of the suction hose sub-assembly with compressor oil (ND-OIL 11).
Install the 2 O-rings onto the suction hose sub-assembly.
Do not let foreign matter adhere to the O-ring or O-ring seal.
Engage the suction pipe sub-assembly and suction hose sub-assembly by matching the alignment marks.
| *1 | Large Diameter Section of Piping Clamp |
| *2 | Alignment Mark |
Insert them by holding the pipe, not the piping clamp.
Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction pipe sub-assembly.
| *a | Large Diameter Section of Piping Clamp |
When inserting, make sure that a click sound is heard.
Check that the suction pipe sub-assembly is securely inserted by pulling it.
17751
2.INSTALL NO. 1 AIR CLEANER INLET
Temporarily install the No. 1 air cleaner inlet.
Install the bolt.
3.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
4.WARM UP COMPRESSOR
5.INSPECT FOR REFRIGERANT LEAK