Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR › from 2013.12
RM2170E _58 Vehicle Interior _057042 HEATING / AIR CONDITIONING _0278138 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)

a.
E234955E03
2.406,0.74 2.198,0.25 false 2.76,0.75 2.99,0.479 false 2.271,2.208 2.51,2.698 false 2.51,2.26 2.917,2.313 false 2.552,2.635 2.75,2.833 0.198,0.198 10 true *a 2.938,2.229 3.135,2.427 0.198,0.198 10 true *b 1.375,1.427 1.563,1.635 0.188,0.208 10 false A 1.375,1.74 1.563,1.948 0.188,0.208 10 false B 0.906,2.458 1.094,2.667 0.188,0.208 10 false C 2.563,0.156 2.781,0.375 0.219,0.219 10 false X 2.073,0.146 2.302,0.323 0.229,0.177 10 false a 3.021,0.375 3.25,0.552 0.229,0.177 10 false b

Install the No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Mark Measurement
A 61.1 mm (2.41 in.)
B 47.7 mm (1.88 in.)
C 50 mm (1.97 in.)


Text in Illustration
*a Secured Part
*b Sensor Part

NOTICE:
·

Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).

·

After inserting the thermistor, do not apply excessive force to the wire.

·

Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".




Hide 88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 87050 4.INSTALL AIR CONDITIONING RADIATOR ASSEMBLY