Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Front Door) › from 2015.11
RM2170E _59 Vehicle Exterior _057045 WINDOW / GLASS _0278151 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 85720D 2.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

Hide 3.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Hide 68102 4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 5.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67602 7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 8.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 9.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 10.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 12.INITIALIZE POWER WINDOW CONTROL SYSTEM