Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278196 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Hazard Warning Switch Circuit  


DESCRIPTION

The combination meter assembly receives the hazard warning signal switch ON signal and controls the operation of the hazard warning lights.

WIRING DIAGRAM

E224262E14
1.552,0.844 1.833,1.01 0.281,0.167 10 false 1 1.729,0.844 2.01,0.99 0.281,0.146 10 false E 2.667,0.854 2.979,1.01 0.313,0.156 10 false TB 2.938,0.854 3.146,1.031 0.208,0.177 10 false 4 4.813,0.854 5.083,1.021 0.271,0.167 10 false 3 5,0.948 5.521,1.198 0.521,0.25 10 false HAZ 4.583,1.417 4.938,1.615 0.354,0.198 10 false G3 4.573,1.563 6.625,2.094 2.052,0.531 10 false Combination Meter Assembly 1.375,1.427 1.771,1.635 0.396,0.208 10 false G2 1.375,1.583 3.885,1.896 2.51,0.313 10 false Hazard Warning Signal Switch

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter / Data List.


e.

Read the display on the intelligent tester.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Hazard Flasher Switch Hazard switch signal/ON or OFF ON: Hazard switch on
OFF: Hazard switch off
-

OK:

Normal conditions listed above are displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
2.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
a.

Remove the hazard warning signal switch assembly (See page Vehicle Exterior>LIGHTING (EXT)>HAZARD WARNING SWITCH>REMOVAL).


b.

Inspect the hazard warning signal switch assembly (See page Vehicle Exterior>LIGHTING (EXT)>HAZARD WARNING SWITCH>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the G3 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G2-4 (TB) - G3-3 (HAZ) Always Below 1 Ω
G2-4 (TB) - Body ground Always 10 kΩ or higher
G2-1 (E) - Body ground Always Below 1 Ω




OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR