Home › Engine / Hybrid System › 1NZ-FXE (COOLING) › EXHAUST HEAT RECIRCULATION SYSTEM › from 2017.06
RM2170E _51 Engine / Hybrid System _057009 1NZ-FXE COOLING _0320239 EXHAUST HEAT RECIRCULATION SYSTEM G

1NZ-FXE COOLING  EXHAUST HEAT RECIRCULATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17410 1.INSPECT FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

a.

Inspect the exhaust flow control valve operation.

i.

Remove the exhaust pipe gas control actuator sub-assembly.

Click hereEngine / Hybrid System>1NZ-FXE (COOLING)>EXHAUST PIPE GAS CONTROL ACTUATOR>REMOVAL


ii.
A279075

Using a screwdriver, move the exhaust flow control valve towards the bottom of the vehicle. Check that the exhaust flow control valve moves smoothly.

OK:

Exhaust flow control valve moves smoothly.


If the exhaust flow control valve is stuck or does not move smoothly, replace the front exhaust pipe assembly (TWC: Rear Catalyst).


iii.

Install the exhaust pipe gas control actuator sub-assembly.

Click hereEngine / Hybrid System>1NZ-FXE (COOLING)>EXHAUST PIPE GAS CONTROL ACTUATOR>INSTALLATION



b.

Inspect the exhaust pipe gas control actuator sub-assembly.

i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.


v.
A279074

While checking the engine coolant temperature with the GTS, check the operation of the exhaust pipe gas control actuator rod when the engine coolant temperature rises.

Standard:
Condition Rod Operation
Cold (below approx. 71°C (160°F)) → Warmed up (approx. 80°C (176°F) or higher) Exhaust pipe gas control actuator rod gradually extends smoothly as the temperature rises


If the exhaust pipe gas control actuator rod does not extend smoothly, replace the exhaust pipe gas control actuator sub-assembly.

HINT:
·

After the engine has warmed up (the thermostat temperature is approximately 80°C (176°F) or higher), the exhaust pipe gas control actuator rod should be extended approximately 5.7 mm (0.224 in.) or more compared to when the engine is cold (the thermostat temperature is below 71°C (160°F)).


·

The engine coolant temperature shown in the Data List may slightly deviate from the thermostat temperature. This is because the Data List value indicates the temperature detected by the engine coolant temperature sensor, which is mounted on the engine, while the thermostat is positioned in the exhaust pipe gas control actuator sub-assembly.


·

If it is difficult to check that the exhaust pipe gas control actuator rod is operating, allow the engine to cool down until the engine coolant temperature matches the ambient temperature and then check the exhaust pipe gas control actuator rod operation again.




vi.

Check for any cracks or damage on the exhaust pipe gas control actuator rod.

OK:

No cracks or damage is found.


If any cracks or damage is found, replace the front exhaust pipe assembly (TWC: Rear Catalyst).



Hide 2.INSPECT FOR ENGINE COOLANT LEAK FROM FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)