PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Power Door Lock Control System | ( )
|
POWER WINDOW CONTROL SYSTEM PRECAUTIONS
The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
The power window control system prohibits the auto up and down function when the jam protection function or catch protection function malfunctions. Therefore, troubleshoot the power window control system after confirming that no DTCs are output.
If the power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
If the power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if the power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
The jam protection function or catch protection function may operate unexpectedly even when the power window control system is normal due to detection of a value different from the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
A power window is being opened or closed while the vehicle is driven on a rough road.
A power window is being opened or closed while the door is being opened or closed.
The voltage changes abruptly.
Do not disconnect the auxiliary battery while the power switch is on (IG). Otherwise, DTC B2313 will be stored.