Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › from 2017.06
RM2170E _59 Vehicle Exterior _057045 WINDOW / GLASS _0278147 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)  


DESCRIPTION

If a door glass does not slide smoothly or the power window regulator motor assembly (for driver door) does not operate smoothly, the catch protection function may be triggered automatically, resulting in the auto down operation being unable to fully open the window.

CAUTION / NOTICE / HINT

NOTICE:
·

If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

·

If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION



HINT:

This symptom may occur for any of the power windows.


PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
a.

Initialize the power window regulator motor assembly (for driver door).

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION (FOR DRIVER DOOR))
2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION (FOR DRIVER DOOR))
a.

Check that driver door power window moves when the auto up and down functions of the power window regulator master switch assembly are operated.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

Driver door power window auto up and down functions are normal (applicable location).



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

3.CHECK WINDOW GLASS SLIDING MOVEMENT (FOR DRIVER DOOR)
3.CHECK WINDOW GLASS SLIDING MOVEMENT (FOR DRIVER DOOR)
a.

Remove the window regulator.


b.

Install the window glass onto the door glass run.


c.

Check that the door window regulator operates smoothly.


d.

Check that the window glass slides smoothly when sliding it down by hand.

NOTICE:

Make sure to perform initialization again.


HINT:
Ensure the following:
·

The window glass fits in the door glass run without improper contact or deformation.

·

Foreign matter is not caught in the door glass run.

·

The door glass run is not misaligned.

·

The window glass is not tilted and does not catch on the door glass run.



OK:

Door window glass slides smoothly.



Result:
Proceed to
OK
NG



OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR)

NG

FIT DOOR GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)