Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
Do not remove the steering sensor from the spiral cable.
1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE HORN BUTTON ASSEMBLY
45100
3.REMOVE STEERING WHEEL ASSEMBLY
| *a | Matchmark |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable.
| *a | Turn |
| *b | Hold |
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
4.REMOVE STEERING PAD SWITCH ASSEMBLY
84632
5.REMOVE CRUISE CONTROL SWITCH
84633
6.REMOVE CRUISE CONTROL SWITCH WIRE
Remove the cruise control switch wire.
45184
7.REMOVE LOWER STEERING WHEEL BOSS COVER
Disengage the 2 pins and 4 claws to remove the lower steering wheel boss cover from the steering wheel sub-assembly.