82142A
1.INSTALL NO. 2 INSTRUMENT PANEL WIRE (w/o Occupant Classification System)
| *a | Airbag Connector |
| *b | Airbag Connector Lock |
Connect the airbag connector of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector to the instrument panel passenger airbag assembly.
Connect the No. 2 instrument panel wire to the instrument panel passenger airbag assembly clamp.
82142A
2.INSTALL NO. 2 INSTRUMENT PANEL WIRE (w/ Occupant Classification System)
| *a | Airbag Connector |
| *b | Airbag Connector Lock |
Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the 2 airbag connector locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.
| *a | Vent Hole Connector |
| *b | Vent Hole Connector Lock |
Connect the vent hole connector of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the vent hole connector lock to install the vent hole connector to the instrument panel passenger airbag assembly.
73960A
3.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/o Occupant Classification System)
Engage the 3 hooks.
Push the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the 2 screws to install the instrument panel passenger airbag assembly.
Engage the clamp to the upper instrument panel assembly.
73960A
4.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/ Occupant Classification System)
Engage the 3 hooks.
Push the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the 2 screws to install the instrument panel passenger airbag assembly.
Engage the clamp to the instrument panel passenger airbag assembly.
Engage the clamp to the upper instrument panel assembly.
5.INSTALL NO. 2 HEATER TO REGISTER DUCT ASSEMBLY
6.INSTALL UPPER INSTRUMENT PANEL ASSEMBLY
82142A
7.CONNECT NO. 2 INSTRUMENT PANEL WIRE (w/o Occupant Classification System)
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
82142A
8.CONNECT NO. 2 INSTRUMENT PANEL WIRE (w/ Occupant Classification System)
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the 2 connectors.
When connecting any airbag connector, take care not to damage the airbag wire harness.
62211
9.INSTALL FRONT PILLAR GARNISH RH
10. PERFORM DIAGNOSTIC SYSTEM CHECK